When you install the drip edge over this strip it keeps the lower flange further from the home s siding which helps to keep water further from the home.
Retrofit roof drip edge.
No calk galvanized steel drip edge pipe flashing model 11815 11 92 11 92.
Install drip edges on the eaves first.
Item 15551 model 5610400120.
Slide the flat bar under starter course and pry out the nails.
You may need to use a putty knife to break the seam between the first course and the starter strip.
Shop 30 14 results for drip edge flashing.
Set your store to see local availability.
It s made by genoa the same people that make the plastic gutters.
I just tuned in to this thread.
Seems the drip edge plastic slides between the shingle and roof sheathing and barbs on the strip hold it in place without nailing.
Use a flat pry bar to remove drip edge nails along the eave and rakes.
The drip edge is the bottom edge where if you had gutters the water would fall in there.
Place the drip edge down aligning it so water will drip into the gutters.
If it doesn t pull the drip edge out slightly from under the shingles.
Is the roof edging missing on both or just the drip.
Of drip edge in the amount of time the first 10 ft.
While the vertical leg should be placed 1 4 1 2 away from the fascia.
The weight of the shingles keeps the edging flat.
The gable or rake edge is that edge which runs up the roof pitch.
Make sure the outer edge extends over the gutter.
At 7 05 paul begins replacing the drip edge roof flashing.
How to install a drip edge.
One is the drip edge and the other is the rake or gable edge.
A furring edge is a strip of one by two wood you install on the vertical surface of the house just beneath the roof s edge.
The 1x2 or 1 1 2 x 1 1 2 simply slides underneath the roof shingles and fastened with a few nails for the drip edge.
Secure the drip edge with roofing cement.
To install a drip edge on a newly constructed roof or on a re roofing job attach the drip edge along the roof s eaves first.
Using this method i put in 120 ft.
The roof leg should extend a minimum of 2 back onto the roof sheathing.
I also ran some roofing nails through the drip edge into the fascia and topped the nails with some white gutter seal.
Amerimax c3s 1 5 in x 10 ft unpainted galvanized galvanized steel drip edge.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.