New motor and wind sensor.
Replacing electric rv awning motor.
Install a new motor and tighten the bolts.
Replacing the motor on a solara power awning extend your awning about 2 feet.
It should be available at any of your local rv dealerships or repair facilities.
Use the manual override if the motor is completely.
Tie the awning arms off to the bracket where it attaches to the side of your rv.
With the motor just clicking it does sound like the motor is locked up.
If that does not happen then the motor has gone bad.
The awning is a secondary covering attached to the exterior of the rv.
Any suggestions for brand or type will be greatly appreciated.
Client on a budget.
Rather than pay 800 to replace the broken arm on my 15 year old 17 dometic ae weatherpro awning i am thinking seriously about replacing it with a new awning with more adjustments for shade.
This will give you room to work.
Loosen the bolts holding it in place and lift it out of the housing.
By doing this the motor should start to operate and extend or retract the awning.
Studies suggest that an awning canopy can keep temperatures cooler to as much as 20 degrees.
If worried about how to convert from manual to electric awning here is the diy process.
There can be several reasons for that and a repair man should be able to check on that.
Locate the supply connection terminal on the motor and connect it with the battery supply wires that you will have.
The instructions for removal and reinstallation will be included with the motor as well.
Learn more how to install a carefree electric awning and also wha.
I have liked the convenience of the electric but did not like the straight out canopy.
Installing an electric awning can be easy if you re prepared and ready to tackle a big job.
Unbolt the chain from the drive shaft of the awning motor.
If this is the case unplug the motor from the electrical source.
Connect the chain for the awning and plug into the electrical supply.
