Remote Control Ceiling Fan Light Wont Turn Off

Make sure the blue wire from the receiver is wired to the blue or black with white stripe if a hunter from the fan.

Remote control ceiling fan light wont turn off.

Change the switch setting to match the settings of the hand held remote control. If the lights are still stuck on at this point it is time to replace the receiver. Dipswitches are toggle switches on the back of the remote. If the above does not resolve the issue continue to the following steps to check for over heating.

Typically there is also a wall switch. It is controlled by a remote control only no switch. One of the wires from the ceiling should be capped off usually the red one. This will sync the ceiling fan remote with the receiver.

Clean and lubricate the ball bearings. If you want to stop the fan but still use the light you have to use the pull cord or the remote. Run the ceiling fan for a few minutes. Reset the remote of your fan.

Turn of your fan using its dedicated remote control. Resetting your remote setting is easy and it only takes a few easy steps. Replace the ceiling fan capacitor. I hope this helps.

You will also find a corresponding set of dipswitches on the fan. Open the battery cover of your remote control under the battery will be a set of dip switches match the dip switch code from your old remote to the new remote test to see if the lights can be turned off. The process will change the frequency settings and allow the remote to work again. However the light on the fan works and the remote does control the light.

Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. Hunter fan remote reset follows the same steps making the troubleshooting easy. Turn on the power from the mains. If the fan sometimes turns on by itself off by itself or the light kit does this on it s own then this is a good sign you do need to change the dipswitches.

Generally you ll need to open the housing to find it. The bad news is the fan canopy must be dropped to access the receiver. The fan is on and won t turn off. You can use that to turn the fan on and off.

Reset the fan remote. Once complete return the battery and cover the remote. If you want to reset the remote. But if you have a unit that has both a light and a fan the wall switch will usually turn off both of them.

Turn off the ceiling fan using the remote. When i turn the power back on the fan goes back on. If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow. To determine the cause of the fan speed malfunction follow the steps below.

The first step is to see if the remote was faulty. I tried replacing the battery for the remote already and i tried turning off the power to the house. Turn off the ceiling fan and allow the blades to come to a full stop. The remote module has a set of small dip switches on the side of the module.